TM 9-2320-366-34-4
NOTE
• Position two spacers on frame rails with beveled
edges facing down.
• Use
bolts
P/N
12414307-148
and
P/N
12414307-149 and self-locking nuts P/N
12414308-025 on steps (27) and (28).
• Left and right side of rear main crossmember
support is installed the same way. Right side
shown.
• Route connectors and terminal lugs under rear
main crossmember.
(27) Position two spacers (46) and rear main crossmember
support (47) on LH and RH frame rails (48 and 36) with
four bolts (49) and self-locking nuts (50).
(28) Position two bolts (51) and self-locking nuts (52) on rear
main crossmember support (47).
NOTE
Use bolts P/N 12414307-079 and self-locking
nuts P/N 12414308-021 on step (29).
(29) Position six bolts (53) and self-locking nuts (54) on rear
lower crossmember support (43).
NOTE
Rotate cable assembly with terminal lugs 180
degrees (upside down) from previous
position.
(30) Route terminal lugs TL32 (19), TL31 (25), and TL30 (30)
to three ground terminals (55).
Change 1
18-57
