TM 9-2320-366-34-4
(37) Remove 45-degree grease fitting (56) from support (8).
(38) Install grease fitting (57) in support (8).
NOTE
• Use bolts P/N 12414307-142 and self-locking
nuts P/N 12414308-025 on step (39).
• Support will be installed with fitting facing down.
(39) Position support (8) on pintle hook extension (39) with
four bolts (7) and self-locking nuts (6).
(40) Position pintle hook extension (39) in vise.
(41) Tighten four self-locking nuts (6) to 196-240 lb-ft (265-
325 N·m).
(42) Position pintle hook (4) in pintle hook extension (39) with
washer (3) and nut (2).
CAUTION
Clearance between washer and support must
be 0.003-0.017 in. (0.076-0.432 mm). Failure
to comply may result in damage to
equipment.
(43) Adjust nut (2) until clearance is 0.003-0.017 in. (0.076-
0.432 mm) with alignment holes lined up between nut (2)
and pintle hook (4).
(44) Install cotter pin (1) in nut (2).
Change 1
18-59
