TM 9-2320-366-34-4
18-5. M1085 PINTLE HOOK EXTENSION KIT INITIAL INSTALLATION (CONT)
a. Installation.
(1) Remove cotter pin (1) from nut (2). Discard cotter pin.
(2) Remove nut (2) and washer (3) from pintle hook (4).
WARNING
Pintle hook weighs approximately 65 lbs
(30 kgs). Attach a suitable lifting device
prior to removal. Failure to comply may
result in injury to personnel or damage to
equipment.
(3) Remove pintle hook (4) from rear crossmember (5).
(4) Remove four self-locking nuts (6), bolts (7), and support
(8) from rear crossmember (5). Discard self-locking
nuts.
NOTE
• Left and right clamps are removed the same
way. Right side shown.
• Remove plastic cable ties as required.
(5) Remove self-locking nut (9), screw (10), and clamp (11)
from L-bracket (12).
18-52
Change 1
