TM 9-2320-366-34-4
18-5. M1085 PINTLE HOOK EXTENSION KIT INITIAL INSTALLATION (CONT)
NOTE
Use bolts P/N 12414307-143 and self-locking
nuts P/N 12414308-025 on step (21).
(21) Install pintle hook extension (39) on rear crossmember
(5) with two bolts (40) and self-locking nuts (41).
(22) Match mark four top holes (42) on rear crossmember
(5).
(23) Remove two self-locking nuts (41), bolts (40) and pintle
hook extension (39) from rear crossmember (5).
(24) Drill four 0.375 in. (9.5 mm) pilot holes in rear
crossmember (5) at matchmarks.
(25) Drill four 0.75 in. (19 mm) holes in rear crossmember (5).
NOTE
Use bolts P/N 12414307-140 and self-locking
nuts P/N 12414308-025 on step (26).
(26) Position rear lower crossmember support (43) on rear
crossmember (5) with two bolts (44) and self-locking nuts
(45).
18-56
Change 1
