TM 9-2320-366-34-2
CAUTION
Do not use pneumatic wrench to remove bolts.
Thread damage will occur. Failure to comply
may result in damage to equipment.
(3) Remove three bolts (7) from support (8).
(4) Loosen bolt (9) from support (8).
NOTE
Left and right upper end of V-rod control arm
are removed the same way. Left side shown.
(5) Remove two-bolts (10) from V-rod control arm (6).
(6) Perform step (5) on right side.
NOTE
Step (7) requires the aid of an assistant.
(7) Remove V-rod control arm (6) from vehicle.
(8) Match mark V-rod control arm (6) and support (8).
(9) Position V-rod control arm (6) in vise.
(10) Remove self-locking nut (11) and support (8) from V-rod
control arm (6). Discard self-locking nut.
(11) Remove bolt (9) from support (8).
Change 1
13-421
