TM 9-2320-366-34-2
WARNING
Adhesives, solvents, and sealing compounds
can burn easily, can give off harmful vapors,
and are harmful to skin and clothing. To
avoid injury or death, keep away from open
fire and use in a well-ventilated area.
If
adhesive, solvent, or sealing compound gets
on skin or clothing, wash immediately with
soap and water.
Failure to comply may
result in injury to personnel.
(9) Apply sealant to threads of three bolts (6) and bolt (1).
CAUTION
Do not use pneumatic wrench to install bolts.
Thread damage will occur. Failure to comply
may result in damage to equipment.
(10) Position three bolts (6) in support (2).
(11) Tighten three bolts (6), bolt (1), and two bolts (5) to 398-
486 lb-ft (540-660 N·m).
(12) Position bracket (7) on V-rod control arm (3) with two U-
bolts (8), four spacers (9), washers (10), and nuts (11).
(13) Tighten four nuts (11) to 14-18 lb-ft (20-24 N·m).
e. Follow-On Maintenance.
Install driveshaft (TM 9-2320-366-20-4).
End of Task.
Change 1
13-423/(13-424 Blank)
