TM 9-2320-366-34-2
Section II. MAINTENANCE PROCEDURES
14-2. FRONT LEAF SPRING REPLACEMENT
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Engine shut down (TM 9-2320-366-10-1).
Front drive shaft removed (left side) (TM 9-
2320-366-20-4).
Gravel deflector and gravel deflector
extension removed (TM 9-2320-366-20-4).
Tools and Special Tools
Tool Kit, Genl Mech (Item 78, Appendix B)
Wrench, Torque, 0-175 lb-ft (Item 92,
Appendix B)
Wrench, Torque, 0-200 lb-in. (Item 93,
Appendix B)
Wrench, Torque, 0-600 lb-ft (Item 97,
Appendix B)
Jack, Dolly Type, Hydraulic (Item 37,
Appendix B)
Tools and Special Tools (Cont)
Trestles, Motor Vehicle Maintenance (2) (Item 81,
Appendix B)
Goggles, Industrial (Item 28, Appendix B)
Wrench Set, Socket (Item 84, Appendix B)
Socket, Left Front Leaf Spring U-Bolt (Item 11, Appendix
D)
Materials/Parts
Nut, Self-Locking (4) (Item 215, Appendix F)
Pin, Cotter (Item 374, Appendix F)
Nut, Self-Locking (2) (Item 235, Appendix F)
Grease, Automotive and Artillery (Item 34, Appendix C)
U-bolt (2) (Item 20.3, Appendix F)
Personnel Required
(2)
WARNING
Wear appropriate eye protection when
working under vehicle due to the
possibility of falling debris.
Failure to
comply may result in injury to personnel.
a. Removal.
(1) Deleted
(2) Deleted
(3) Remove wheel on side that leaf spring is being removed
(TM 9-2320-366-10-1).
14-2
Change 1
