TM 9-2320-366-34-2
13-47. V-ROD CONTROL ARM REPLACEMENT (CONT)
d. Rear Installation.
(1) Position bolt (1) in support (2).
(2) With matchmarks aligned, position support (2) on V-rod
control arm (3) with self-locking nut (4).
(3) Tighten self-locking nut (4) to 590-736 lb-ft (800-1000
N·m).
(4) Remove V-rod control arm (3) from vise.
NOTE
Step (5) requires the aid of an assistant.
(5) Position V-rod control arm (3) on vehicle.
WARNING
Adhesives, solvents, and sealing compounds
can burn easily, can give off harmful vapors,
and are harmful to skin and clothing. To
avoid injury or death, keep away from open
fire and use in a well-ventilated area.
If
adhesive, solvent, or sealing compound gets
on skin or clothing, wash immediately with
soap and water.
Failure to comply may
result in injury to personnel.
NOTE
Left and right upper end of V-rod control arm
are installed the same way. Left side shown.
(6) Apply sealant to threads of two bolts (5).
(7) Position two bolts (5) in V-rod control arm (3).
(8) Perform steps (6) and (7) on right side.
13-422
Change 1
