TM 9-2320-366-34-2
NOTE
Step (5) requires the aid of an assistant.
(5) Position V-rod control arm (3) on vehicle.
WARNING
Adhesives, solvents, and sealing compounds
can burn easily, can give off harmful vapors,
and are harmful to skin and clothing. To
avoid injury or death, keep away from open
fire and use in a well-ventilated area.
If
adhesive, solvent, or sealing compound gets
on skin or clothing, wash immediately with
soap and water.
Failure to comply may
result in injury to personnel.
NOTE
Left and right upper end of V-rod control arm
are installed the same way. Left side shown.
(6) Apply sealant to threads of two bolts (5).
(7) Position two bolts (5) in V-rod control arm (3).
(8) Perform steps (6) and (7) on right side.
WARNING
Adhesives, solvents, and sealing compounds
can burn easily, can give off harmful vapors,
and are harmful to skin and clothing. To
avoid injury or death, keep away from open
fire and use in a well-ventilated area.
If
adhesive, solvent, or sealing compound gets
on skin or clothing, wash immediately with
soap and water.
Failure to comply may
result in injury to personnel.
(9) Apply sealant to threads of two bolts (6 and 1).
CAUTION
Do not use pneumatic wrench to install bolts.
Thread damage will occur. Failure to comply
may result in damage to equipment.
(10) Position two bolts (6) in support.
(11) Tighten two bolts (6 and 1) and four bolts (5) to 398-486
lb-ft (540-660 N·m).
Change 1
13-419
