TM 9-2320-366-34-3
(80) Install seal plate (108), three preformed packings (109),
and preformed packing (110) on top directional valve
body (73).
WARNING
Adhesive Sealant MIL-S-46163 can damage
your eyes.
Wear safety goggles/glasses
when using; avoid contact with eyes.
If
sealant contacts eyes, flush eyes with water
and get immediate medical attention. Failure
to comply may result in injury to personnel.
(81) Apply sealing compound to threads of four screws (111).
(82) Install pilot valve body (106) on top directional valve
body (73) with four screws (111).
(83) Perform steps (76) through (82) on remaining three pilot
valve bodies.
e. Installation.
(1) Install eight knobs (1) on levers (2).
(2) Apply sealing compound to threads of eight bolts (3).
NOTE
Steps (3) and (4) require the aid of an
assistant.
(3) Position valve manifold (4) in crane control panel (5) with
eight washers (6), lockwashers (7), and bolts (3).
(4) Tighten bolts (3) to 41-45 lb-ft (55-61 N m).
(5) Connect three hydraulic tubes (8) to valve manifold (4).
(6) Install hydraulic tube (9) on valve manifold (4) and
accumulator (10).
16-333
