TM 9-2320-366-34-3
16-21. M1084/M1086 GEAR SET REPAIR (CONT)
NOTE
All three gears are assembled the same way.
One gear shown.
(7) Install two roller sets (8) and separator (9) in gear (10).
(8) Install gear (10) and two washers (11) in carrier (12) with
pin (13).
WARNING
Use care when installing retaining rings.
Retaining rings are under tension and can
act as projectiles when released. Failure to
comply may result in injury to personnel.
(9) Install retaining ring (14) on pin (13).
(10) Perform steps (7) through (9) on two remaining gears
(10).
(11) Install washer (15) in carrier (12).
NOTE
All three gears are assembled the same way.
One gear shown.
(12) Install retaining ring (16) on drive gear (17).
(13) Install drive gear (17) in carrier (18).
(14) Install retaining ring (19) on drive gear (17).
(15) Install roller set (20) in gear (21).
(16) Install two washers (22) and gear (21) in carrier (18) with
pin (23).
(17) Install retaining ring (24) on pin (23).
(18) Perform steps (12) through (17) on two remaining gears
(21).
16-104
