TM 9-2320-366-34-3
15-8. M1090 REAR FENDER MOUNTING BRACKET AND EXTENSION BRACKET
REPLACEMENT
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Dump body raised to maintenance position (TM 9-
2320-366-10-1).
Rear fender removed (TM 9-2320-366-20-4).
Tools and Special Tools
Tool Kit, Genl Mech (Item 78, Appendix B)
Goggles, Industrial (Item 28, Appendix B)
Wrench, Torque, 0-600 lb-ft (Item 97, Appendix B)
Tools and Special Tools (Cont)
Wrench Set, Socket (Item 84, Appendix B)
Materials/Parts
Bolt (2) (Item 7, Appendix F)
Bolt (3) (Item 8, Appendix F)
Nut, Self-Locking (5) (Item 205, Appendix F)
Personnel Required
(2)
WARNING
Wear appropriate eye protection when
working under vehicle due to the
possibility of falling debris. Failure to
comply may result in injury to personnel.
a. Removal.
CAUTION
When removing bolts, continuous removal of
collars is mandatory. Failure to comply will
result in seizing of collar to bolt.
NOTE
• Left and right side rear fender mounting
brackets and extension brackets are removed
the same way. Left side shown.
• Steps (1) and (2) require the aid of an assistant.
(1) Remove two collars (1), bolts (2), and extension bracket
(3) from rear fender mounting bracket (4).
Discard
collars and bolts.
(2) Remove three collars (5), bolts (6), and rear fender
mounting bracket (4) from frame rail (7). Discard collars
and bolts.
15-123
