TM 9-2320-366-34-3
15-7. CAB WINDSHIELD, SIDE WINDOW AND DOOR SIDE WINDOW
REPLACEMENT (CONT)
CAUTION
While twine is being removed from inside of
cab, always tap behind the twine (with soft
head hammer) on outside of cab to seat seal.
Always start from RH lower part of windshield
and work to the LH side of vehicle. DO NOT
start tapping at the middle of the windshield.
Failure to comply may result in damage to
equipment.
(6) Remove RH side of twine until twine is 12 in. (305 mm)
up RH side on windshield (1) as shown.
(7) Remove LH side of twine until twine is 12 in. (305 mm)
up LH side of windshield (1) as shown.
CAUTION
After using windshield setting tool, tap bottom
section of seal lightly with soft head hammer to
ensure proper fit with cab. Use caution not to
hit glass.
Failure to comply may result in
damage to equipment.
(8) Insert bottom of seal (2) evenly with cab (3) using
windshield setting tool and soft head hammer.
(9) Pull down on LH and RH top corners (4 and 5) of
windshield (1).
15-120.4
Change 1
