TM 9-2320-366-34-2
10-5. INTERMEDIATE AXLE DIFFERENTIAL PINION SEAL, YOKE SEAL AND DRIVE
YOKE REPLACEMENT (CONT)
NOTE
Step (7) requires the aid of an assistant.
(7) Remove propeller shaft (7) from frame (8).
WARNING
Do not use steel hammers to seat bearing
cups in drive yokes. Failure to comply may
result in injury to personnel or damage to
equipment.
CAUTION
Check bearing cups to ensure all needle
bearings are in place to installation. Replace
bearing cups if needle bearings are missing or
out of place. Failure to comply may result in
damage to equipment.
NOTE
Wipe end of yoke bearing bores prior to
insallation.
(8) Position universal joint (9) on drive yoke (4) with two
bearing cups (10) and four screws (11).
NOTE
Alternately tighten screws.
When correct torque is reached, bearing cap
screw small hex head will break off.
(9) Tighten four screws (11).
CAUTION
Grease must flow from all four seals. Failure
to comply may result in damage to
equipment.
(10) Apply lubrication to grease fittings (TM 9-2320-366-20).
10-32
Change 1
