TM 9-2320-366-34-2
NOTE
Input and output pinion and yoke seals and
drive yokes are removed the same way. Input
pinion and yoke seals and drive yoke shown.
(4) Remove drive yoke nut (7) from pinion shaft (8). Discard
drive yoke nut.
(5) Place drain pan under pinion shaft (8).
(6) Remove drive yoke (3) from pinion shaft (8).
NOTE
Vehicles serial number 0001 through 3133,
were not originally equipped with yoke seals.
Yoke
seals
may
not
be
present
if
maintenance has not been previously
performed on drive yoke.
(7) Remove yoke seal (9) from drive yoke (3). Discard yoke
seal.
(8) Remove pinion seal (10) from intermediate differential
carrier (11). Discard pinion seal.
b. Installation.
NOTE
Input and output pinion and yoke seals and
drive yokes are installed the same way. Input
pinion and yoke seals and drive yoke shown.
(1) Apply a small amount of grease to outside edge and
spring cavity of pinion seal (1).
(2) Install pinion seal (1) in intermediate differential carrier
(2).
(3) Visually verify pinion seal (1) is properly seated.
(4) Install yoke seal (3) on drive yoke (4).
(5) Install drive yoke (4) on pinion shaft (5) with drive yoke
nut (6).
(6) Tighten drive yoke nut (6) to 450-601 lb-ft (610-815
N·m).
Change 1
10-31
