TM 9-2320-366-34-2
10-6. INTERMEDIATE AXLE DIFFERENTIAL CARRIER REPLACEMENT
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Engine shut down (TM 9-2320-366-10-1).
Differential oil drained (TM 9-2320-366-20).
Axle shaft removed (TM 9-2320-366-20-4).
Tools and Special Tools
Tool Kit, Genl Mech (Item 78, Appendix B)
Goggles, Industrial (Item 28, Appendix B)
Wrench, Torque, 0-175 lb-ft (Item 92, Appendix B)
Hammer, Hand, Soft Hand (Item 33, Appendix B)
Tools and Special Tools (Cont)
Lift, Transmission/Differential (Item 39, Appendix
B)
Sling, Cargo (Item 56, Appendix B)
Materials/Parts
Sealant, Adhesive (Item 68, Appendix C)
Screw, Cap (4) (Item 366.1, Appendix F)
Personnel Required
(2)
WARNING
Wear appropriate eye protection when
working under vehicle due to the
possibility of falling debris.
Failure to
comply may result in injury to personnel.
a. Removal.
(1) Remove four screws (1) and two bearing cups (2) from
drive yoke (3). Discard screws.
(2) Slide drive shaft (4) from side to side and separate
universal joint (5) from drive yoke (3).
NOTE
Step (3) requires the aid of an assistant.
(3) Attach drive shaft (4) to frame (6).
Change 1
10-33
