TM 9-2320-366-34-2
10-5. INTERMEDIATE AXLE DIFFERENTIAL PINION SEAL, YOKE SEAL AND DRIVE
YOKE REPLACEMENT
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Engine shut down (TM 9-2320-366-10-1).
Tools and Special Tools
Tool Kit, Genl Mech (Item 78, Appendix B)
Puller Kit, Universal (Item 51, Appendix B)
Wrench Set, Socket, (Item 84, Appendix B)
Driver, Intermediate Input Yoke Seal (Item 52,
Appendix D)
Multiplier, Torque Wrench (Item 42, Appendix B)
Goggles, Industrial (Item 28, Appendix B)
Driver, Intermediate Output Yoke Seal (Item 53,
Appendix D)
Wrench, Torque, 0-600 lb-ft (Item 97, Appendix B)
Socket, Socket Wrench (TM 9-2320-366-20)
Wrench, Impact, Electric (Item 88, Appendix B)
Socket Set, Impact (Item 58, Appendix B)
Sling, Cargo (Item 56, Appendix B)
Tools and Special Tools (Cont)
Driver, Intermediate Differential Output (Rear) Seal
(Item 50, Appendix D)
Driver, Differential Pinion Seal (Item 51, Appendix
D)
Pan, Drain (Item 43, Appendix B)
Holding Bar, Pinion (TM 9-2320-366-20)
Materials/Parts
Grease, Automotive and Artillery (Item 35,
Appendix C)
Parts Kit, Seal Replacement (Item 313.4, Appendix
F)
Parts Kit, Seal Replacement (Item 313.5, Appendix
F)
Screw, Cap (4) (Item 366.1, Appendix F)
Nut, Self-Locking (Item 193, Appendix F)
Personnel Required
(2)
WARNING
Wear appropriate eye protection when
working under vehicle due to the possibility
of falling debris.
Failure to comply may
result in injury to personnel.
a. Removal.
(1) Remove four screws (1) and two bearing cups (2) from
drive yoke (3). Discard screws.
(2) Slide drive shaft (4) from side to side and separate
universal joint (5) from drive yoke (3).
NOTE
Step (3) requires the aid of an assistant.
(3) Attach drive shaft (4) to frame (6).
10-30
Change 1
