TM 9-2320-366-34-2
NOTE
• Position spring pin so groove faces slot in bracket.
• Lubricate spring pin before installation.
• Step (6) requires the aid of an assistant.
(6) Install leaf spring (1) in front bracket (10) with spring pin
(11).
(7) Install lubrication fitting (12) in spring pin (11).
(8) Position bolt (13) and nut (14) in front bracket (10).
(9) Tighten self-locking nut (14) to 76-94 lb-ft (103-127
N m).
(10) Raise front axle (2) until it contacts leaf spring (1).
(11) Position plate (15) on leaf spring (1).
(12) Position two U-bolts (16), four washers (17), and self-
locking nuts (18) on plate (15).
(13) Tighten four self-locking nuts (18) to 200 lb-ft (271 N m),
in sequence shown.
(14) Re-tighten four self-locking nuts (18), in increments of 50
lb-ft (68 N·m) to 390-510 lb-ft (529-692 N·m), in
sequence shown.
NOTE
Perform steps (15) through (18) on RH side
of vehicle.
(15) Position cab tilt cylinder (19) on bracket (20).
(16) Install washer (21) and cotter pin (22) in cab tilt cylinder
(19).
Change 1
14-7
