TM 9-2320-366-34-4
(42) Position spring (40), shift fork (41), and shift collar (42)
on differential carrier (14).
(43) Install preformed packing (43) on inter-axle shift shaft
(44).
(44) Position inter-axle shift shaft (44) and inter-axle shift
cylinder (45) on differential carrier (14).
(45) Tighten inter-axle shift cylinder (45) to 80-100 lb-ft (108-
136 N·m).
(46) Install bearing cup (46) in differential carrier (14).
(47) Install bearing cup (47) in differential carrier (14).
(48) Install bearing cone (48) on inter-axle rear side gear
(49).
(49) Install shims (50) on inter-axle rear side gear (49).
(50) Position inter-axle rear side gear (49) in differential
carrier (14).
(51) Install bearing cone (51) on inter-axle side gear (49).
NOTE
End play should be 0.001-0.006 in. (0.002-0.015
cm), if the end play is too high, remove shims.
If there is no end play, add shims.
(52) Measure inter-axle rear slide gear (49) end play.
(53) Repeat steps (48) through (52) until end play is within
specifications.
24-17
