24-2. INTERMEDIATE DIFFERENTIAL REPAIR (CONT)
Perform step (6) if backlash reading is
greater than 0.018 in. (0.045 cm).
(6) Tighten adjusting ring (3) on backside of hub body (4)
and loosen adjusting ring (3) facing the ring gear (5) to
(7) Repeat steps (2) through (6) until backlash is between
0.008-0.018 in. (0.020-0.045 cm).
(8) Install two cotter pins (6) on differential bearing caps (7).
approximately 350 lbs (159 kgs). Attach a
suitable lifting device prior to removal.
Failure to comply may result in injury to
personnel or damage to equipment.
Step (9) requires the aid of an assistant.
(9) Remove differential carrier (1) from differential carrier
End of Task.