TM 9-2320-366-34-4
18-3. M1090/M1094 PINTLE HOOK EXTENSION KIT INITIAL INSTALLATION (CONT)
NOTE
Use bolts P/N 12414307-141 and self-locking
nuts P/N 12414308-025 on step (54).
(54) Position two bolts (79) and self-locking nuts (80) in rear
lower crossmember support (62).
(55) Tighten two self-locking nuts (64 and 80) to 196-240 lb-ft
(265-325 N·m).
(56) Tighten six self-locking nuts (73) to 76-94 lb-ft (103-125
N·m).
(57) Tighten four bolts (68) and two bolts (70) to 236-288 lb-ft
(319-389 N·m).
(58) Tighten two self-locking nuts (15) on L-brackets (12).
NOTE
Left and right clamps are installed the same
way. Right side shown.
(59) Install clamp (11) on L-bracket (12) with screw (10) and
self-locking nut (9).
(60) Perform step (59) on left side clamp.
NOTE
Install plastic cable ties as required.
(61) Connect connector J53 (33) to connector P53 (34).
18-32
Change 1
