TM 9-2320-366-34-4
22-3. TRANSFER CASE MODULE REPAIR (CONT)
b. Assembly.
NOTE
Apply lubricating oil to all parts during
assembly.
(1) Install C7 clutch housing (1) in transfer case module (2).
(2) Position gasket (3) and front output housing (4) on
transfer case module (2) with 15 screws (5).
(3) Tighten 15 screws (5) to 44-55 lb-ft (60-75 N·m).
(4) Install yoke (6), washer (7), and nut (8) on front output
shaft (9).
(5) Tighten nut (8) to 450-600 lb-ft (610-814 N·m).
(6) Rotate transfer case module (2) until transfer case cover
(10) is facing up.
(7) Install P4 planetary carrier (11) and sun gear (12) in
transfer case module (2).
(8) Position gasket (13) and rear output housing (14) on
transfer case module (2) with nine screws (15) and six
screws (16).
(9) Tighten nine screws (15) and six screws (16) to 44-55 lb-
ft (60-75 N·m).
22-8
Change 1
