TM 9-2320-366-34-4
(16) Install bushing (22) in end housing (23).
(17) Install bearing (24) in end housing (23).
NOTE
Transfer matchmarks to replacement parts
prior to installation.
(18) Position end housing (23) on stator (17) with
matchmarks aligned.
(19) Position nine self-locking nuts (25) on stator (17).
(20) Tighten nine self-locking nuts (25) to 45 lb-in. (5 N·m).
WARNING
Adhesive
Sealant
MIL-S-46163
can
damage your eyes. Wear safety goggles
when using; avoid contact with eyes. If
sealant contacts eyes, flush eyes with
water
and
get
immediate
medical
attention. Failure to comply may result in
injury to personnel.
(21) Apply sealing compound to threads of screw (26) and
five screws (27).
(22) Position jumpers (28 and 29) and terminal lug (30) on
front housing (15) with washer (31) and screw (26).
(23) Position five terminal lugs (32) and jumpers (33) on front
housing (15) with five washers (34) and screws (27).
(24) Tighten screw (26) and five screws (27) to 30 lb-in. (3
N·m).
Change 1
18-71
