TM 9-2320-366-34-4
18-6. 200 AMP ALTERNATOR REPAIR (CONT)
(35) Remove six self-locking nuts (74) and washers (75) from
rotor (76). Discard self-locking nuts.
(36) Match mark rotor (76) to shaft (3).
(37) Install three jacking screws in small threaded holes in
rotor (76).
(38) Remove rotor (76) from shaft (3) by alternately turning
three jacking screws two full turns.
(39) Remove three jacking screws from rotor (76).
(40) Remove nut (77), lockwasher (78), washer (79), and fuse
(80) from 24 vdc post (33). Discard lockwasher.
(41) Remove nut (81), lockwasher (82), and washer (83) from
12 vdc post (39). Discard lockwasher.
b. Assembly.
(1) Position washer (1) and lockwasher (2) on 12 vdc post
(3) with nut (4).
(2) Position fuse (5), washer (6), and lockwasher (7) on 24
vdc post (8) with nut (9).
18-68
Change 1
