TM 9-2320-366-34-3
(49) Install plunger (48) in motor end support (42).
(50) Install brake shaft (53) in plunger (48).
NOTE
Alternately stack ten friction disc brakes and
nine brake drive plates.
(51) Install ten friction disc brakes (54) and nine brake drive
plates (55) in plunger (48).
(52) Install two dowels (56) in plunger (48).
(53) Install preformed packing (57) on brake housing (58).
(54) Install bearing (59) in brake housing (58).
(55) Position brake housing (58) on motor end support (42)
with matchmarks aligned.
(56) Position six lockwashers (60) and screws (61) in brake
housing (58).
(57) Tighten six screws (61) to 45-55 lb-ft (61-75 N·m).
(58) Install 45-degree fitting (62) and 90-degree fitting (63) in
brake housing (58).
(59) Install banding strap (64) around motor end support (42)
and gear end support (5).
(60) Reposition drum (1) with gear end support (5) and motor
end support (42) on work bench.
(61) Install preformed packing (65) on hydraulic motor (66).
(62) Position hydraulic motor (66) on brake housing (58) with
two lockwashers (67), and screws (68).
(63) Tighten two screws (68) to 70-95 lb-ft (32-43 N·m).
16-367
