TM 9-2320-366-34-3
16-63. 30K WINCH ASSEMBLY REPLACEMENT/REPAIR (CONT)
WARNING
30K winch assembly weighs approximately
1450 lbs (658 kgs).
Use suitable lifting
device prior to installation.
Failure to
comply may result in injury to personnel or
damage to equipment.
A guide rope must be attached to 30K winch
frame to aid in controlling 30K winch
assembly during installation.
Failure to
comply may result in injury to personnel or
damage to equipment.
NOTE
Step (4) requires the aid of two assistants.
(4) Position 30K winch assembly (2) on vehicle.
WARNING
Adhesive
Sealant
MIL-S-46163
can
damage your eyes. Wear safety goggles
when using; avoid contact with eyes. If
sealant contacts eyes, flush eyes with
water
and
get
immediate
medical
attention. Failure to comply may result in
injury to personnel.
(5) Apply sealing compound to threads of six screws (8).
NOTE
Left and right side of 30K winch assembly
are installed the same way. Left side shown
(6) Position 12 washers (9), six screws (8), and self-locking
nuts (10) in 30K winch assembly (2).
(7) Tighten six self-locking nuts (10) to 152-168 lb-ft (206-
227 N·m).
(8) Perform steps (6) and (7) on right side of 30K winch
assembly (2).
16-370
