TM 9-2320-366-34-3
(64) Install seal (79) on head valve push button (80).
(65) Install preformed packing (81) on head valve (82).
(66) Install head valve coil (83), head valve push button (80),
and head valve (82) in solenoid (78).
(67) Install preformed packing (84) on valve body coil (85).
(68) Install valve body coil (85) and valve body push button
(86) in solenoid (78).
(69) Install access cover (87) on solenoid (78) with four
screws (88).
(70) Perform steps (63) through (69) on remaining solenoids.
NOTE
All pilot valve bodies are assembled the
same way.
Lift Control pilot valve body
shown.
(71) Install spool (89) in pilot valve body (90).
WARNING
Adhesive sealant MIL-S-46163 can damage
your eyes. Wear safety goggles/glasses
when using; avoid contact with eyes. If
sealant contacts eyes, flush eyes with
water
and
get
immediate
medical
attention. Failure to comply may result in
injury to personnel.
(72) Apply sealing compound to threads of eight screws (87).
(73) Position two preformed packings (91) and solenoids (78)
on pilot valve body (90) with eight screws (87).
(74) Tighten eight screws (87) to 30-45 lb-in. (3-5 N·m).
16-161
