TM 9-2320-366-34-3
16-26. M1084/M1086 OUTRIGGER JACK CYLINDER REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Equipment Conditions
Jack cylinder lowered approximately 12 inches
(TM 9-2320-366-10-1).
Engine shut down (TM 9-2320-366-10-1).
Tools and Special Tools
Tool Kit, Genl Mech (Item 78, Appendix B)
Jack, Dolly Type, Hydraulic (Item 37, Appendix B)
Pan, Drain (Item 43, Appendix B)
Materials/Parts
Cap and Plug Set (Item 17, Appendix C)
Lockwasher (4) (Item 138, Appendix F)
Pin, Cotter (2) (Item 326, Appendix F)
Packing, Preformed (2) (Item 236, Appendix F)
Packing, Preformed (2) (Item 235, Appendix F)
Personnel Required
(2)
a.
Removal.
NOTE
Left and right outrigger jack cylinders are
removed the same way. Right side shown.
(1) Disconnect connector (1) from cable (2).
(2) Remove four screws (3), lockwashers (4), and cover
plate (5) from outrigger (6). Discard lockwashers.
(3) Position floor jack under jack cylinder (7).
(4) Place drain pan under hoses (8).
16-129
