TM 9-2320-366-34-3
16-17. M1084/M1086 HYDRAULIC MOTOR CONTROL VALVE REPLACEMENT
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Engine shut down (TM 9-2320-366-10-1).
Tools and Special Tools
Tool Kit, Genl Mech (Item 78, Appendix B)
Materials/Parts
Cap and Plug Set (Item 17, Appendix C)
Lockwasher (4) (Item 139, Appendix F)
Materials/Parts (Cont)
Packing, Preformed (Item 262, Appendix F)
Packing, Preformed (Item 236, Appendix F)
Packing, Preformed (2) (Item 237, Appendix F)
Packing, Preformed (2) (Item 265, Appendix F)
Packing, Preformed (2) (Item 231, Appendix F)
Dispenser, Pressure Sensitive Adhesive Tape
(Item 30, Appendix C)
a. Removal.
CAUTION
Cap or plug hydraulic hoses and fittings to
prevent contamination of hydraulic system.
Failure to comply may result in damage to
equipment.
NOTE
Tag hoses and connection points prior to
disconnecting.
(1) Disconnect two hoses (1) from fittings (2).
(2) Disconnect hose (3) from 45-degree fitting (4).
(3) Remove four screws (5), lockwashers (6), and hydraulic
motor control valve (7) from hydraulic motor (8). Discard
lockwashers.
16-87
