TM 9-2320-366-34-3
(5) Remove 90-degree fitting (3) from hoist hydraulic motor
(1).
(6) Remove preformed packings (9 and 10) from 90-degree
fitting (3). Discard preformed packings.
b. Installation.
(1) Install preformed packings (1 and 2) on 90-degree fitting
(3).
(2) Install 90-degree fitting (3) on hoist hydraulic motor (4).
(3) Install unsplined end of boss coupling (5) in hoist
assembly (6).
WARNING
Adhesive Sealant MIL-S-46163 can damage
your eyes.
Wear safety goggles/glasses
when using; avoid contact with eyes.
If
sealant contacts eyes, flush eyes with water
and get immediate medical attention. Failure
to comply may result in injury to personnel.
(4) Apply sealing compound to threads of two screws (7).
(5) Position gasket (8) and hoist hydraulic motor (4) on hoist
assembly (6) with two washers (9) and screws (7).
(6) Tighten screws (7) to 60-90 lb-ft (81-122 N·m).
16-93
