TM 9-2320-366-34-2
10-7. REAR AXLE ASSEMBLY REPLACEMENT
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Rear stabilizer disconnected from rear axle
assembly (TM 9-2320-366-20-4).
Rear wheels removed (TM 9-2320-366-10-2).
Air tanks drained (TM 9-2320-366-10-1).
Tools and Special Tools
Tool Kit, Genl Mech (Item 78, Appendix B)
Lift, Transmission/Differential (Item 39,
Appendix B)
Jack, Leveling Support, Vehicle (TM 9-2320-
366-20)
Jack, Dolly Type, Hydraulic (Item 37, Appendix
B)
Wrench, Torque, 0-600 lb-ft (Item 97, Appendix
B)
Trestle, Motor Vehicle Maintenance (2) (Item
81, Appendix B)
Multiplier, Torque Wrench (Item 42, Appendix
B)
Tools and Special Tools (Cont)
Wrench, Torque, 0-175 lb-ft (Item 92, Appendix B)
Wrench Set, Socket (Item 84, Appendix B)
Goggles, Industrial (Item 28, Appendix B)
Wrench Set, Crowfoot, Ratcheting (TM 9-2320-366-20)
Sling, Cargo (2) (Item 56, Appendix B)
Hammer, Hand, Soft Head (Item 33, Appendix B)
Materials/Parts
Dispenser, Pressure Sensitive Adhesive Tape (Item 30,
Appendix C)
Sealing Compound (Item 75, Appendix C)
Sealing Compound (Item 69, Appendix C)
Screw, Cap (8) (Item 366.1, Appendix F)
Nut, Self-locking (4) (Item 214.1, Appendix F)
Personnel Required
(3)
WARNING
Wear appropriate eye protection when
working under vehicle due to the possibility
of falling debris.
Failure to comply may
result in injury to personnel.
a. Removal.
(1) Place trestles under rear of vehicle.
NOTE
Steps (2) through (4) require the aid of an
assistant.
(2) Remove four screws (1) and two bearing cups (2) from
drive yoke (3). Discard screws.
(3) Slide drive shaft (4) from side to side and separate
universal joint (5) from drive yoke (3).
(4) Attach drive shaft (4) to frame (6).
Change 1
10-37
