TM 9-2320-366-34-2
14-9. REAR AXLE SHOCK ABSORBER BRACKET REPLACEMENT
This task covers:
a. Rear Axle Shock Absorber Front Bracket
Removal
b. Rear Axle Shock Absorber Front Bracket
Installation
c. Rear Axle Shock Absorber Rear Bracket
Removal
d. Rear Axle Shock Absorber Rear Bracket
Installation
e. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Engine shut down (TM 9-2320-366-10-1).
Underlift lowered (M1089) (TM 9-2320-366-10-2).
Tools and Special Tools
Tool Kit, Genl Mech (Item 78, Appendix B)
Goggles, Industrial (Item 28, Appendix B)
Wrench, Torque, 0-600 lb-ft (Item 97,
Appendix B)
Wrench Set, Socket (Item 84, Appendix B)
Wrench, Impact, Electric (Item 88, Appendix B)
Tools and Special Tools (Cont)
Socket Set, Impact (Item 58, Appendix B)
Materials/Parts
Bolt (Item 5, Appendix F)
Bolt (Item 6, Appendix F) (front bracket)
Bolt (Item 7, Appendix F) (rear bracket)
Nut, Self-locking (3) (Item 229, Appendix F)
Personnel Required
(2)
WARNING
Wear appropriate eye protection when
working under vehicle due to the
possibility of falling debris. Failure to
comply may result in injury to personnel.
a. Rear Axle Shock Absorber Front Bracket Removal.
NOTE
• Left and right side rear axle shock absorber
front brackets are removed the same way.
Right side shown.
• Perform step (1) on vehicle serial numbers 0001
through 1398 and 2988 and higher serial
numbers.
(1) Remove self-locking nut (1), bolt (2), and washer (3)
from rear axle shock absorber (4). Discard self-locking
nut.
14-42
