TM 9-2320-366-34-4
26-3. M1084/M1086 SWING DRIVE HYDRAULIC MOTOR REPAIR (CONT)
(15) Install preformed packing (14) on geroler (15).
CAUTION
Position geroler with largest star point aligned
with marked bolt hole on motor housing. Failure
to comply may result in damage to equipment.
(16) Install geroler (15) on spur gear shaft (12).
(17) Install preformed packing (16) on geroler (15).
(18) Position end cap (17) on geroler (15) with seven screws
(18).
CAUTION
Tighten screws in a crisscross pattern to
properly seat end cap. Failure to comply may
result in damage to equipment.
(19) Tighten screws (18) to 15-40 lb-in. (2-5 N·m).
(20) Verify geroler (15) and preformed packings (14 and 16)
are properly seated.
(21) Tighten screws (18) to 20-30 lb-ft (27-41 N·m).
End of Task.
26-18
