TM 9-2320-366-34-4
(5) Position motor housing (2) in vise with output shaft (1)
up.
WARNING
Adhesive Sealant MIL-S-46163 can damage
your eyes. Wear safety goggles when using;
avoid contact with eyes. If sealant contacts
eyes, flush eyes with water and get
immediate medical attention.
Failure to
comply may result in injury to personnel.
(6) Apply sealing compound to four screws (10).
(7) Position motor housing flange (8) on output shaft (1) with
four screws (10).
CAUTION
Tighten screws in a crisscross pattern to
properly seat mounting flange.
Failure to
comply may result in damage to equipment.
(8) Tighten screws (10) to 21 lb-ft (28 N·m).
(9) Reposition motor housing (2) in vise with output shaft (1)
down.
CAUTION
Mark bolt hole on motor housing that aligns
with timing mark on output shaft. Failure to
comply may result in damage to equipment.
(10) Align timing mark on output shaft (1) with any bolt hole
in motor housing (2).
(11) Install preformed packing (11) on motor housing (2).
(12) Install spur gear shaft (12) in output shaft (1).
(13) Fill motor housing (2) with lubricating oil.
(14) Install spacer plate (13) on motor housing (2).
26-17
