TM 9-2320-366-34-4
24-2. INTERMEDIATE DIFFERENTIAL REPAIR (CONT)
b. Cleaning/Inspection.
WARNING
Dry Cleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles and
gloves; use only in well ventilated area; avoid contact with skin, eyes, and clothes, and
do not breathe vapors. Keep away from heat or flame. Never smoke when using solvent;
the flashpoint for Type I Dry Cleaning Solvent is 100°F (38°C) and for Type II is 130°F
(50°C). Failure to comply may result in serious injury or death to personnel.
If personnel become dizzy while using cleaning solvent, immediately get fresh air and
medical help. If dry cleaning solvent contacts skin or clothes, flush with cold water. If dry
cleaning solvent contacts eyes, immediately flush eyes with water and get immediate
medical attention. Failure to comply may result in injury to personnel.
(1) Clean sealant residue from threaded holes with dry
cleaning solvent.
CAUTION
Wash machined parts separately to avoid
damage from parts bumping together. Failure to
comply may result in damage to equipment.
(2) Clean all metal parts with dry cleaning solvent.
WARNING
Compressed
air
used
for
cleaning
purposes will not exceed 30 psi (207 kPa).
Use only with effective chip guarding and
p e r s o n a l
p r o t e c t i v e
e q u i p m e n t
(goggles/shield, gloves, etc.). Failure to
comply may result in injury to personnel.
(3) Dry all metal parts, except bearing cones with
compressed air. Allow bearing cones to air dry.
NOTE
Replace any part that fails visual inspection.
(4) Inspect oil filter screen (1) for visible cracks, tears or
damage.
(5) Inspect oil pump cover (2) for visible cracks or damage.
24-8
