TM 9-2320-366-34-4(2) Attach dial indicator on mounting flange of differentialcarrier (1).(3) Adjust dial indicator so pointer is against tooth surface ofring gear (2).(4) Adjust dial indicator to zero.(5) Rotate ring gear (2) a small amount in both directions.Dial indicator should read between 0.008-0.018 in.(0.020-0.045 cm). Record results.(6) Perform steps (2) through (5) at two other locations onring gear (2).(7) Remove oil filter screen (3) from pump cover (4).(8) Remove nine screws (5), washers (6), and oil pumpcover (4) from differential carrier (1).(9) Remove oil pump (7) from pinion drive shaft (8).(10) Loosen self-locking nut (9) on pinion drive shaft (8).(11) Loosen self-locking nut (10) on input yoke (11).(12) Loosen self-locking nut (12) on output yoke (13).(13) Remove eight screws (14), washers (15), input bearingcage (16), three shims (17) and preformed packing (18)from differential carrier (1). Discard preformed packing.Change 1 24-3
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business