TM 9-2320-366-34-4
24-2. INTERMEDIATE DIFFERENTIAL REPAIR (CONT)
NOTE
Perform steps (6) through (8) if pinion drive
and drive gear set were replaced. If old
pinion drive and drive gear is installed, go to
step (9).
(6) Record pinion cone variation number at gear end of
pinion drive shaft (9).
(7) Record thickness of shim pack (10) that was removed
from pinion drive shaft (9).
NOTE
The pinion cone variation number can be either 1000th of an in. or 1000th of a cm. For example, PC
+4 equals +0.004 in., PC-0.005 cm equals -0.005 cm.
Table 24-1. Pinion Cone Variation Chart
PINION CONE VARIATION NUMBER
EQUIVALENT MEASUREMENT
PC +1 through PC +9
+0.001 in. through +0.009 in.
+1 through +9
PC -1 through PC -9
-0.001 in. through -0.009 in.
-1 through -9
PC +0.001 cm through PC +0.009 cm
+0.001 cm through +0.009 cm
+0.001 cm through +0.009 cm
PC -0.001 cm through PC -0.009 cm
-0.001 cm through -0.009 cm
-0.001 cm through -0.009 cm
(8) If pinion cone variation number recorded in step (42) of
disassembly is negative, subtract it from the thickness of
the shim pack. If number is positive, add it to the
thickness of the shim pack.
24-12
