TM 9-2320-366-34-3
CAUTION
Use care when installing captive screws.
Failure to comply may result in damage to
equipment.
NOTE
• Lubricate all captive screws prior to installation.
• All captive screws are installed the same way.
One captive screw shown.
• Tighten nut until captive screw is seated.
(9) Install captive screw (15) in cab rear wall (2) with washer
and nut.
(10) Remove nut and washer from captive screw (15).
(11) Perform steps (9) and (10) on remaining nine captive
screws.
(12) Position five centering cups (16) on cab rear wall (2) with
five screws (17).
(13) Tighten five screws (17) to 62-124 lb-in. (7-14 N·m).
NOTE
• Perform steps (14) through (20) on left and right
sides of cab rear wall. Right side shown.
• Tighten nut until captive screw is seated.
(14) Install captive screw (18) in cab rear wall (2) with washer
and nut.
(15) Remove nut and washer from captive screw (18).
(16) Install seal (19) on cab rear wall (2).
(17) Position centering cup (20) on cab rear wall (2) with
screw (21).
(18) Tighten screw (21) to 62-124 lb-in. (7-14 N·m).
(19) Position friction catch (22) on cab rear wall (2) with two
screws (23).
(20) Tighten two screws (23) to 62-124 lb-in. (7-14 N·m).
Change 1
15-105
