TM 9-2320-366-34-3
15-6. M1093/M1094 CAB WINDSHIELD FRAME REPLACEMENT/REPAIR
This task covers:
a. Removal
b. Disassembly
c. Assembly
d. Installation
e. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
M1093/M1094 cab roof removed (TM 9-2320-366-
20-4).
Cab windshield removed (para 15-7).
Tools and Special Tools
Tool Kit, Genl Mech (Item 78, Appendix B)
Wrench, Torque, 0-200 lb-in. (Item 93, Appendix
B)
Wrench, Torque, 0-175 lb-ft (Item 92, Appendix B)
Wrench Set, Socket (TM 9-2320-366-20)
Socket Set, Socket Wrench (Item 59, Appendix B)
Materials/Parts
Washer, Flat (Item 94, Appendix C)
Nut, Self-locking (Item 53, Appendix C)
Screw, Captive (10) (Item 368, Appendix F)
Seal (79 in. (2000 mm)) (Item 372, Appendix F)
Lubricating Oil, Engine (Item 49, Appendix C)
Seal (2) (87 in. (2200 mm)) (Item 372, Appendix F)
Personnel Required
(3)
a. Removal.
NOTE
Left and right side wiper arms are removed
the same way. Left side shown.
(1) Disconnect windshield washer hose (1) from fitting (2).
(2) Lift cover (3) at base of wiper arm (4).
(3) Remove nut (5) and lockwasher (6) from wiper arm shaft
(7). Discard lockwasher.
NOTE
Mark position of wiper arm prior to removal.
(4) Remove wiper arm (4) from wiper arm shaft (7).
(5) Perform steps (1) through (4) on right side wiper arm.
15-110
