TM 9-2320-366-34-3
15-5. M1093/M1094 CAB REAR WALL REPLACEMENT/REPAIR
This task covers:
a. Removal
b. Disassembly
c. Assembly
d. Installation
e. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
M1093/M1094 cab roof removed (TM 9-2320-366-20-4).
M42 Alarm removed, if equipped.
Spare tire lowered (TM 9-2320-366-10-2).
Tools and Special Tools
Tool Kit, Genl Mech (Item 78, Appendix B)
Socket Set, Socket Wrench (Item 59, Appendix B)
Wrench Set, Socket (TM 9-2320-366-20)
Socket Wrench Attachment, Screwdriver (TM 9-2320-
366-20)
Wrench, Torque, 0-200 lb-in. (Item 93, Appendix B)
Wrench, Torque, 0-175 lb-ft (Item 92, Appendix B)
Wrench, Torque, 0-75 lb-in. (Item 98, Appendix B)
Tool Kit, Blind Rivet (Item 76, Appendix B)
Materials/Parts
Washer, Flat (Item 94, Appendix C)
Nut, Self-locking (Item 53, Appendix C)
Seal (2) (30 in. (750mm)) (Item 366, Appendix
F)
Screw, Captive (12) (Item 368, Appendix F)
Insulation Panel (Item 72, Appendix F)
Insulation Panel (Item 73, Appendix F)
Insulation Panel (Item 74, Appendix F)
Insulation Panel (Item 75, Appendix F)
Insulation Panel (Item 76, Appendix F)
Insulation Panel (Item 77, Appendix F)
Lubricating Oil, Engine (Item 41, Appendix C)
Personnel Required
(2)
a. Removal.
(1) Release three latches (1) on clamps (2).
(2) Remove davit (3) from three clamps (2).
(3) Remove dustcap (4) from connector J62 (5).
(4) Remove screw (6) and dustcap (4) from cab rear wall
(7).
(5) Remove three screws (8) and connector J62 (5) from
cab rear wall (7).
15-98
Change 1
