TM 9-2320-366-34-3
15-4. M1093/M1094 CAB SIDE WALL REPLACEMENT/REPAIR (CONT)
(3) Install seal (4) on cab side wall (2).
(4) Position four centering cones (5) on cab side wall (2)
with four screws (6).
(5) Tighten four screws (6) to 62-124 lb-in. (7-14 N·m).
CAUTION
Use care when installing captive screws.
Failure to comply may result in damage to
equipment.
NOTE
• Lubricate captive screws prior to installation.
• All captive screws are installed the same way.
One shown.
• Tighten nut until captive screw is seated.
(6) Install captive screw (7) in cab side wall (2) with washer
and nut.
(7) Remove nut and washer from captive screw (7).
(8) Perform steps (6) and (7) on remaining captive screws.
(9) Position two friction catch studs (8) on cab side wall (2)
with four screws (9), washers (10) and nuts (11).
(10) Position three hinges (12) on cab side wall (2) with six
washers (13) and screws (14).
(11) Tighten six screws (14) to 22-28 lb-ft (30-38 N·m).
15-94
