TM 9-2320-366-34-2
13-12. M1094 EXTRACTION TUBE AND EXTENSION BRACKET REPLACEMENT (CONT)
(8) Remove eight nuts (22), lockwashers (23), bolts (24),
washers (25), and extraction block (16) from extraction
tube (4). Discard lockwashers.
b. Installation.
NOTE
Left and right side extraction tubes are
installed the same way. Left side shown.
(1) Position extraction tube (1) in vise.
(2) Position extraction block (2) in extraction tube (1) with
eight washers (3), bolts (4), lockwashers (5) and nuts
(6).
(3) Tighten eight nuts (6) to 210-225 lb-ft (285-305 N·m).
(4) Position mounting plate (7) on extraction tube (1) with
two washers (8), bolts (9), lockwashers (10), and nuts
(11).
(5) Tighten two nuts (11) to 33-45 lb-ft (45-61 N·m).
(6) Install washer (12) and tie-down ring (13) in extraction
block (2).
(7) Remove extraction tube (1) from vise.
13-80