TM 9-2320-366-34-2
13-14. M1083 FRAME PLATE REPLACEMENT
This task covers:
a. LH Removal
b. LH Installation
c. RH Removal
d. RH Installation
e. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Rear axle bogie shaft removed (para 10-4).
Rear torque rods removed (para 14-5).
Resilient mount and mechanical stops removed (TM
9-2320-366-20-4).
15K Self-Recovery winch (SRW) cable pulleys
removed, if equipped (RH side) (TM 9-2320-366-20-
5).
Tools and Special Tools
Tool Kit, Genl Mech (Item 78, Appendix B)
Goggles, Industrial (Item 28, Appendix B)
Wrench, Torque, 0-150 lb-in. (Item 91, Appendix B)
Wrench, Torque, 0-175 lb-ft (Item 92, Appendix B)
Wrench, Torque, 0-600 lb-ft (Item 97, Appendix B)
Wrench Set, Socket (Item 84, Appendix B)
Wrench Set, Socket (Item 85, Appendix B)
Materials/Parts
Nut, Self-locking (Item 202, Appendix F)
Materials/Parts (Cont)
Lockwasher (Item 166, Appendix F)
Nut, Self-locking (Item 173, Appendix F) (LH
side)
Nut, Self-locking (2) (Item 173, Appendix F) (RH
side)
Nut, Self-locking (8) (Item 212, Appendix F)
Bolt (20) (Item 2, Appendix F) (LH side)
Nut, Self-locking (20) (Item 204, Appendix F) (LH
side)
Bolt (19) (Item 2, Appendix F) (RH side with
winch)
Nut, Self-locking (19) (Item 204, Appendix F)
(RH side with winch)
Bolt (21) (Item 2, Appendix F) (RH side without
winch)
Nut, Self-locking (21) (Item 204, Appendix F)
(RH side without winch)
Bolt (10) (Item 7, Appendix F)
Nut, Self-locking (10) (Item 211, Appendix F)
Personnel Required
(2)
WARNING
Wear appropriate eye protection when
working under vehicle due to the
possibility of falling debris.
Failure to
comply may result in injury to personnel.
a. LH Removal.
(1) Remove two self-locking nuts (1), bolts (2), and clamps
(3), from frame plate (4). Discard self-locking nuts.
13-84
