TM 9-2320-366-34-2
13-12. M1094 EXTRACTION TUBE AND EXTENSION BRACKET REPLACEMENT
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Dump body raised (TM 9-2320-366-10-1).
Rear fender removed (TM 9-2320-366-20-4).
Tools and Special Tools
Tool Kit, Genl Mech (Item 78, Appendix B)
Goggles, Industrial (Item 28, Appendix B)
Wrench, Torque, 0-175 lb-ft (Item 92, Appendix B)
Wrench Set, Socket (Item 84, Appendix B)
Wrench, Impact, Electric (Item 88, Appendix B)
Socket Set, Impact (Item 58, Appendix B)
Multiplier, Torque Wrench (Item 42, Appendix B)
Tools and Special Tools (Cont)
Vise, Machinist (Item 82, Appendix B)
Materials/Parts
Lockwasher (16) (Item 142, Appendix F)
Lockwasher (2) (Item 140, Appendix F)
Nut, Self-locking (5), (Item 211, Appendix F)
Bolt (2), (Item 10, Appendix F)
Personnel Required
(2)
WARNING
Wear appropriate eye protection when
working under vehicle due to the
possibility of falling debris. Failure to
comply may result in injury to personnel.
a. Removal.
NOTE
Left and right side extraction tubes are removed
the same way. Left side shown.
Steps (1) through (4) require the aid of an
assistant.
(1) Remove two self-locking nuts (1), bolts (2), and
extension bracket (3) from extraction tube (4). Discard
self-locking nuts.
13-78
