TM 9-2320-366-34-2
13-11. M1083/M1093/M1090/M1094 STRUCTURAL SUPPORT REPLACEMENT
This task covers:
a. M1083/M1093 Removal
b. M1083/M1093 Installation
c. M1090/M1094 Removal
d. M1090/M1094 Installation
e. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Rear crossmember removed (para 13-7).
Rear stabilizer brackets removed (M1090/M1094)
(para 14-10).
Tools and Special Tools
Tool Kit, Genl Mech (Item 78, Appendix B)
Goggles, Industrial (Item 28, Appendix B)
Wrench, Torque, 0-175 lb-ft (Item 92, Appendix B)
Wrench, Torque, 0-600 lb-ft (Item 97, Appendix B)
Wrench Set, Socket (Item 84, Appendix B)
Materials/Parts
Bolt (4) (Item 2, Appendix F) (M1083)
Bolt (4) (Item 3, Appendix F) (M1093)
Materials/Parts (Cont)
Nut, Self-locking (4) (Item 204, Appendix F)
Bolt (4) (Item 9, Appendix F)
(M1083/M1090/M1094)
Bolt (4) (Item 5, Appendix F) (M1090)
Bolt (4) (Item 4, Appendix F) (M1094)
Bolt (4) (Item 10, Appendix F) (M1093)
Nut, Self-locking (4) (Item 204, Appendix F)
Nut, Self-locking (6) (Item 211, Appendix F)
Nut, Self-locking (6) (Item 215, Appendix F)
Ties, Cable Plastic (Item 92, Appendix C)
Personnel Required
(2)
WARNING
Wear appropriate eye protection when
working under vehicle due to the
possibility of falling debris. Failure to
comply may result in injury to personnel.
a. M1083/M1093 Removal.
NOTE
Left and right side of valve control panel is
removed the same way. Right side shown.
Steps (1) through (12) require the aid of an
assistant.
Remove plastic cable ties as required.
(1) Remove three self-locking nuts (1), washers (2), bolts
(3), and washers (4) from valve control panel (5).
Discard self-locking nuts.
(2) Perform step (1) on left side of valve control panel (5).
(3) Position valve control panel (5) for access to structural
support (6).
13-70
