TM 9-2320-366-34-2
12-3. STEERING GEAR ASSEMBLY ADJUSTMENT (CONT)
(43) Turn steering wheel to right until stops are reached.
(44) Check pressure reading on STE/ICE-R.
Pressure
reading should be between 500-1000 psi (3448-6895
kPa).
(45) Shut down engine (TM 9-2320-366-10-1).
(46) Remove plastic cable ties and two steering stop shim
gages from steering stop bolt (15).
(47) Raise vehicle off trestles.
(48) Remove two trestles from vehicle.
(49) Lower vehicle to ground.
(50) Start engine (TM 9-2320-366-10-1).
(51) Turn steering wheel left until stops are reached and
verify pressure increases and then decreases to a range
between 500-1000 psi (3448-6895 kPa).
(52) Turn steering wheel right until stops are reached and
verify pressure increases and then decreases to a range
between 500-1000 psi (3448-6895 kPa).
NOTE
If pressure readings obtained in steps (51)
and (52) are not within range, repeat steps
(24) through (49).
(53) Shut down engine (TM 9-2320-366-10-1).
(54) Disconnect test cable (13) from DCA connector (14).
(55) Raise cab (TM 9-2320-366-10-1).
12-14
