TM 9-2320-366-34-2
12-3.
STEERING GEAR ASSEMBLY ADJUSTMENT
This task covers:
a. Adjustment
INITIAL SETUP
Equipment Conditions
Engine shut down (TM 9-2320-366-10-1).
Tools and Special Tools
Tool Kit, Genl Mech (Item 78, Appendix B)
Wrench, Torque, 0-175 lb-ft (Item 92, Appendix B)
Trestle, Motor Vehicle Maintenance (2) (Item 81,
Appendix B)
Pan, Drain (Item 43, Appendix B)
STE/ICE-R (Item 70, Appendix B)
Crowfoot, Attachment (Item 17, Appendix B)
Gage, Steering Stop Shim (2) (Item 22, Appendix D)
Jack, Dolly Type Hydraulic (2) (Item 37, Appendix B)
Materials/Parts
Coupling, Pipe (Item 24, Appendix C)
Tee, Pipe to Tube (Item 86, Appendix C)
Lubricating Oil, Engine (Item 45, Appendix C)
Ties, Cable, Plastic (Item 92, Appendix C)
Personnel Required
(2)
References:
TM 9-4910-571-12 & P
a. Adjustment.
(1) Remove two screws (1) and washers (2) from front grille
(3).
(2) Remove screw (4), washer (5), and front grille (3) from
cab (6).
NOTE
Step (3) and (4) require the aid of an
assistant.
(3) Raise front axle (7) until wheels are off ground.
(4) Place two trestles under front axle (7).
12-9
