TM 9-2320-366-34-2
3-8. CRANKSHAFT FRONT SEAL REPLACEMENT (CONT)
(9) Tighten four screws (5) to 98-142 lb-ft (133-193 N·m).
(10) Position water pump belt (10) on pulley (9).
CAUTION
Maintain correct belt tension while tightening
screws.
Failure to comply may result in
damage to equipment.
NOTE
•
Belt tension for new belt is 115-125 lbs
(512-556 N). For reinstalled belt 85-95 lbs
(378-442 N).
•
Steps (11) and (12) require the aid of an assistant.
(11) Adjust water pump belt (10) to 115-125 lb (512-556 N).
(12) Tighten screws (11 and 12) to 15-25 lb-ft (20-34 N·m).
c. Follow-On Maintenance.
(1) Install pulley damper (para 3-7).
(2) Start engine (TM 9-2320-366-10-1).
(3) Raise cab (TM 9-2320-366-10-1).
(4) Check crankshaft front seal for oil leaks.
(5) Lower cab (TM 9-2320-366-10-1).
(6) Shut down engine (TM 9-2320-366-10-1).
End of Task.
3-80
