TM 9-2320-366-34-2
CAUTION
Rear crankshaft seal and sleeve ring are
installed with bevel edge toward engine.
Failure to comply may result in damage to
equipment.
(2) Position rear seal (2) in sleeve ring.
(3) Position sleeve ring on rear locator.
(4) Position installer on rear locator with nut.
(5) Tighten nut on installer.
(6) Remove nut, installer and sleeve ring from rear locator.
(7) Rotate sleeve ring 180 degrees.
(8) Position sleeve ring on rear locator.
(9) Position installer on rear locator with nut.
(10) Tighten nut on installer.
(11) Remove nut, installer, and sleeve ring from rear locator.
CAUTION
Ensure rear seal and wear ring are flush.
Failure to comply may result in damage to
equipment.
(12) Remove two screws and rear locator from crankshaft
(1).
d. Follow-On Maintenance.
(1) Install flexplate (para 3-10).
(2) Install engine (para 3-3).
End of Task.
Change 1
3-83
