TM 9-2320-366-34-2
14-10. STABILIZER MOUNTING BRACKET REPLACEMENT
This task covers:
a. Removal
b. Inspection
c. Installation
d. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Rear stabilizer bar removed (TM 9-2320-366-20-4).
Tools and Special Tools
Tool Kit, Genl Mech (Item 78, Appendix B)
Goggles, Industrial (Item 28, Appendix B)
Wrench, Impact, Electric (Item 88, Appendix B)
Socket Set, Impact (Item 58, Appendix B)
Press, Arbor (Item 48, Appendix B)
Tools and Special Tools (Cont)
Wrench, Torque, 0-600 lb-ft (Item 97, Appendix
B)
Wrench Set, Socket (Item 84, Appendix B)
Materials/Parts
Bolt (3) (Item 4, Appendix F)
Nut, Self-Locking (3) (Item 222, Appendix F)
Grease, Automotive and Artillery (GAA) (Item
36, Appendix C)
WARNING
Wear appropriate eye protection when
working under vehicle due to the
possibility of falling debris.
Failure to
comply may result in injury to personnel.
a. Removal.
CAUTION
When removing bolts, continuous removal of
collars is mandatory. Failure to comply will
result in seizing of collar to bolt.
NOTE
Left and right side stabilizer mounting
brackets are removed the same way. Right
side shown.
(1) Remove three collars (1), bolts (2), and mounting bracket
(3) from frame (4). Discard collars and bolts.
Change 1
14-49
